Exoracing An10 Turbo Oil Return Drain Fitting Stainless Steel

Exoracing An10 Turbo Oil Return Drain Fitting Stainless SteelWhy Use An Exoracing An10 Turbo Return Drain Fitting? If you are currently doing a turbo conversion or making a catch can, etc., you would normally weld AN10 fittings for the drain, breather ports, etc., but we now have a solution which requires no welding. The new approach is to drill a hole and tighten both nuts together, creating an incredibly fast way of creating an AN10 male port. Our Exoracing AN10 turbo drain fittings are machined from high

Offside Cable Length: 1705mm

you will need to double-check that the thread of the exhaust or intake studs is M8x1

5 (Female)

guaranteeing protection against heat

rounded or a combination of both over time

Our clamps can also be used for a wide range of uses

Internal Thread Size: M12 x 1

Replace your old

If you need to clean the reflective once it is installed

such as the turbo

65mm Clamp Type: T-Bolt Operating Temperature: -60°C to 180°C Bolt Thread: M6x1

brake caliper Bolt length 77 mm