Billet Swirl Pot Steam Line Merge lt4

Billet Swirl Pot Steam Line Merge lt4Please Read Entire Description Prior To Purchasing These billet weld in components from my private reserve enable you to introduce steam lines into a swirl pot in a way that further promotes the vortex effect for trapped air removal. They have provisions for (4x) 1 8 NPT to 3an fittings for individual head bleed lines and (2x) 1 4 NPT to 4an fittings to handle intake and radiator bleed lines for use as the high point in the system. You can cut these

This is our premium button up workwear shirt as worn by Kyle at every SEMA show

With this bracket you can bolt the pump to the engine block on the front drivers side lower position using the two lower threaded holes near the oil pan

All while adding a new level of  professionalism to your build

This is a mounting solution for the supercharger water pump supplied with the LT4 crate engine (part# 13597903)

No more sketchy "holesaw in a drillpress” this process is faster and makes for a neater job

They have provisions for (4x) 1/8 NPT to -3an fittings for individual head bleed lines and (2x) 1/4 NPT to -4an fittings to handle intake and radiator bleed lines for use as the high point in the system

kuhnhausen@gmail

(affix with rubber band if desired) mark

Approximate placement shown

You will need to file one factory clocking tab on the pump’s rh mounting wing about 1/8” for flush bolting

Disclaimer

Forget the tacky tape