Honda Civic EP3 Splitter Bracket

Honda Civic EP3 Splitter BracketSplitter bracket that bolts on via the m8 threads to the lower edges of the front cross member. Has numerous holes to allow the fitment of ours or your own splitter. 3mm Aluminium TRIMMING TO THE BACK OF THE BUMPER MAY BE REQUIRED FOR LOCAL CLEARANCE DEPENDING ON BUMPER *****This bracket works with our subframe bolts as rear splitter mounts, not on its own*****

We can also supply momentary and / or latching buttons and can also put you in touch with Racing Circuits who can wire it for you or even make this a wireless setup

Options (Number Equates to Options Drop-Down)

In addition

there will be slight distortion on bolt holes but will always go in with a little tension

Trim the dam ends to match the splitter (sheet metal shears or grinder)

Remove bumper or remove the splitter

Replace the front wishbone bolts with the ones supplied

AIM Technologies Solo 2 Mount

Made in the UK from EN24T steel for strength

Do not run this on a car that is so low that this makes contact with the floor or curbs under cornering

only the bolts to attach the modular system together

this is for 1 side add-on not 2 like in the picture